Yamaha DSP-A1 Manual De Instrucciones página 33

10
For the front effect speaker level adjustment, press
the TEST key on the remote control transmitter
again so that "TEST DSP" appears on the display.
Remote control
TEST
A calibration signal should be heard from the main
speakers and the front effect speakers in turn.
11
Adjust the front effect speaker level by pressing the
+ or – key so that it becomes almost as same as
that of the main speakers.
* While adjusting, the test tone is fixed on the front
effect speaker.
Remote control
* Pressing the or
on the left front effect speaker and the right front
effect speaker respectively. This is helpful for you
to check that each speaker is correctly connected
to this unit.
1 2
JAZZ ROCK
CLUB CONCERT
4 5
CONCERT CONCERT
VIDEO 1 VIDEO 2
7 8
MOVIE MOVIE
THEATER 1 THEATER 2
10 11
LEVEL
PARAMETER
10, 12
TEST
SET MENU
SLEEP ON SCREEN
SYSTEM
POWER ON
TV
VCR
STANDBY
Main
Front effect
key makes the test tone fix
3 TAPE 2 MON
ENTER-
TAINMENT
6 PHONO
TV
THEATER
EFFECT
9
/ DTS
ON/OFF
SURROUND
12
11
MASTER VOLUME
MUTE
12
When the adjustment is finished, press the TEST
key once again to cancel the test tone.
Remote control
TEST
Notes
Once you have completed these adjustments, you can
adjust whole sound level on your audio system by using
the VOLUME control (or the MASTER VOLUME keys on
the remote control transmitter) only.
If you use external power amplifiers, you may also use
their volume controls to achieve proper balance.
If the function "1A. CENTER SP" in the SET MENU mode
is set in the "NONE" position, in step 9, the sound output
level of the center speaker cannot be adjusted. This is
because in this mode, the center sound is automatically
output from the left and right main speakers.
If there is insufficient sound output from the center and
rear speakers, you may decrease the main speaker
output level by setting the function "1F. MAIN LEVEL" in
the SET MENU mode in the "–10dB" position.
Disappears
31