Messages - Sony CMT-DX400 Manual De Instrucciones

The language for the sound track cannot be
changed.
• Multilingual tracks are not recorded on the DVD
being played.
• The DVD prohibits changing the language for the
sound track.
The subtitle language cannot be changed.
• Multilingual subtitles are not recorded on the
DVD being played.
• The DVD prohibits changing the subtitles.
The subtitle cannot be turned off.
• The DVD prohibits turning off subtitles.
The angles cannot be changed.
• Multi-angles are not recorded on the DVD being
played.
• The DVD prohibits changing the angles.
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (page 21).
• Connect the antenna properly (page 7).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical equipment.
A stereo FM program cannot be received in
stereo.
• Press AUDIO repeatedly until "STEREO"
appears.
Optional components
There is no sound.
• Refer to General item "There is no sound" (page
28) and check the condition of the system.
• Connect the component properly (page 8) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
GB
28
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
To return the settings to the
default settings*, perform reset
as follows:
The operation can only be set using the TV
screen.
1
Press FUNCTION +/– repeatedly to switch
the function to DVD/CD.
Playback starts automatically if a disc with auto
playback function is loaded. Press x twice to
stop playback.
2
Remove the disc if it is loaded.
3
Press SETUP in stop mode.
The Setup Menu appears.
4
Press < or , repeatedly to select
"Preference Page", then press
5
Press M or m repeatedly to select "Default,"
then press .
"Reset" is selected.
6
Press .
It takes a few seconds to complete. Do not press
?/1 when resetting the system.
* Except for Parental Control settings

Messages

One of the following messages may appear or
flash on the front panel display during operation.
DVD/VIDEO CD/CD/MP3/JPEG/
DivX
LOADING
The disc information is being loaded.
NO DISC
• There is no disc in the unit.
• A disc that cannot be played was loaded.
OPEN
The disc compartment cover is open.
REG ERR
A disc with an unsupported Region code was
loaded.
.