Changing The Presser Foot - JUKI HZL-G220 Manual De Instrucciones

Changing the presser foot

Removing and installing the presser foot
Attention
Turn OFF the power switch before replacing the presser foot.
Presser foot holder
Presser foot
releasing button
Groove in presser
foot holder
Presser foot
marking
Removing and installing presser foot holder
Presser foot holder
Setscrew of presser foot holder
Setscrew of presser
foot holder
Presser foot holder
12
Removing presser foot
1. Raise the needle and presser foot.
2. Press the presser foot releasing button to remove the presser foot.
Presser foot
Installing presser foot
Align the pin of the presser foot and the groove in the presser foot
holder.
Then lower the presser foot holder with the presser foot lifting lever.
Pin
* Each presser foot has a marking. Use the appropriate presser foot
for the stitch pattern to be sewn.
Removing presser foot holder
1. Lift the needle and presser foot lifting lever.
2. Loosen the setscrew of the presser foot holder to the left and re-
Installing presser foot holder
Align the screw hole at the presser bar with the hole of presser foot
Presser bar
holder (long groove). Tighten the setscrew firmly by turning it to the
right side.
move the presser foot holder.