Sewing Letters And One Point Pattern; Preparation Before Sewing; Test Sewing - JUKI HZL-G220 Manual De Instrucciones

Sewing letters and one point pattern

Attention
Turn OFF the power switch before replacing the presser foot.

Preparation before sewing

(in order to sew a pattern neatly, apply interlining and conduct a test sewing first.)
Fabric

Test sewing

C
B
Correct shape When right side is higher than left side,
One point 00~39
Pattern No.
Letters 00~99
Presser foot Manual buttonhole presser foot (I)
Use an iron to attach a fusible interlining to the wrong side of fabric.
* When stitch length becomes too small, the bobbin thread will come out to
the front side of fabric and/or stitches might get stuck. Therefore make sure
to conduct a test sewing beforehand.
Since the pattern might be deformed according to the type and thickness of
fabric and fusible interlining to be used, make sure to conduct test sewing
on the same fabric and interlining.
1. Press
2. Set a piece of fabric and a thread to be used for test sewing.
3. Check the sewn result. If it is not right, change the figure C by stitch
length adjusting button B . Figures "-30" to "+30" can be selected.
4. When
A
Press " " and
adjust it.
button A .
button A is pressed again, screen goes back to normal.
When right side is lower than left side,
Press " " and
adjust it.
41