Setting The Bobbin - JUKI HZL-G220 Manual De Instrucciones

Setting the bobbin

1
Put the bobbin in the bobbin case.
* Place the bobbin so that thread winds counterclock-
wise.
2
B
Thread groove A and B by pulling the thread
end.
* It will be easier to thread grooves when you press the
bobbin lightly with your finger.
3
C
Thread guide C by pulling the thread to left side.
A
4
C
D
E
Thread to guide D and E leave the thread
underneath. (Thread guide E first and it will
thread to guide D as well.)
* When pulling bobbin thread, bobbin rotates counter-
clockwise. If bobbin rotates clockwise, put the bobbin
upside down.
5
Cut the thread with the built-in cutter F .
6
Close the hook cover.
You can start to sew in this condition (without
pulling up the bobbin thread), however, if you want
to sew with the bobbin thread pulled out, refer to
"Pulling up the bobbin thread" in the page 17.
F
15