Tabla de contenido
Publicidad
Before using the space heater, please read carefully all the instructions for use described below and follow the
indications scrupulously.
The manufacturer cannot be held responsible for damage to persons and/or property caused by improper use of
the equipment.
This instruction manual is an integral part of the equipment and must therefore be kept carefully and passed on
with the unit in the event of a change of ownership.
GENERAL RECOMMENDATIONS
The generator described in this manual is a portable oil-fuelled
infrared heat generator.
Its easy handling and large fuel tank allow it to be used locally
and temporarily with complete stand-alone operation.
The area to be heated is therefore hit by an even and uniform
flow of heat, as can be seen by the shape of the irradiation cone
(22), without air movement.
The unit is a direct combustion hot generator that works by
sending both hot air and combustion products in the room you
wish to heat: all the necessary precautions must therefore be
taken to guarantee a sufficient exchange of air.
Always follow local ordinances and codes when using this
heater:
• Read and follow this owner's manual before using the heater;
• Use only in places free of flammable vapours or high dust
content;
• Never use heater in immediate proximity of flammable
materials (the minimum distance must be 3 m);
• Make sure fire fighting equipment is readily available;
• Ensure that the machine resting surface or ground is not
made of flammable material;
• Make sure sufficient fresh outside air is provided according to
the heater requirements. Direct combustion heaters should
only be used in well vented areas in order to avoid carbon
monoxide poisoning;
• Never block air inlet (rear) or air outlet (front);
• In case of very low temperatures add kerosene to the heating
oil;
• Make sure heater is always under surveillance and keep
children
and animals away from it;
• Before starting the heater always check free rotation of
ventilator;
• Unplug heater when not in use.
SAFETY DEVICES
The unit is fitted with an electronic flame control box. In case
of malfunction this box will cut in and stop the heater, at the
same time the pilot lamp in the control box reset button (13) will
light up.
Warning
The re-engagement push-button emits a different
colour light, depending on the state of the
machine:
• green, when the machine is running regularly;
• red, when the machine in safety stop: to restart,
the re-engagement button must be pressed (13)
• yellow, when it is in "stand-by": to restart, it is
not necessary to press the re-engagement push-
button (13), as operation will resume automatically.
Heaters are also equipped with an overheat thermostat safety
cut out which will stop the heater in case of overheating. This
thermostat will reset automatically but you will have to depress
button (13) on control box before being able to restart the heater.
EN
IMPORTANT
OPERATION
Before any attempt of starting the heater is made, check that
your electrical supply conforms to the data on the model plate.
Warning
For models "DV" check that the arrows on the
voltage supply selector key cover are pointing to
the vol-tage value required.
If necessary:
• remove the cover;
• press deflector (23) to the position required;
• replace the protective cover.
Warning
Mains must be fitted with a thermo-magnetic
differential switch.
Unit plug must be linked to a socket with a mains
switch.
The hot generator must be placed on a flat, stable and level
surface to avoid machine tipping and/or gas oil leakage from the
tank fuel cap.
The flow of heat can be directed upward with an approximately
10° angle: loosen the two locking knobs (A) and tilt the
combustion unit by pressing on the handle until the desired angle
is reached, then lock the knobs (A) by screwing them.
Warning
Before start-up, always ensure the guard (B) has
been completely pulled out, so as to guarantee
maximum protection of the machine resting
surface.
12
Publicidad
Tabla de contenido
