Babyauto Savile V8A Manual De Uso página 24

5. Loosen the harness buckle, lift the covers of both the base and
the back of the seat and pass the waist belt under both covers,
and install the vehicle vertical safety belt passing it through guide
R (3.6 and 3.7).
6. Tighten the lap belt and diagonal shoulder belt, then place the red
safety clip on the diagonal shoulder belt tongue as near to the
vehicle anchor point as possible without touching it! (3.8, 3.9 y
3.10).
7. To unfasten the harness press the red button on the buckle
downwards (3.11).
8. For greater space and to loosen the harness, it is necessary to
press the harness adjustment button, while simultaneously
pulling the harness straps down with your other hand (do not pull
the harness protector) (3.12). Place the head support in its lowest
position (3.13).
9. Place the child in the child car safety seat (3.14)
10. Join the 2 buckle metal connectors, pass both connectors through
the slot in the upper part of the buckle until you hear a "click"(3.15).
11. Check that the harness straps lie firmly on the child's chest; the
harness must be adjusted by pressing the harness adjustment
button. The harness should not be twisted. Press the metal button
that is located between the child's legs and then pull the straps
until the child is properly secured and a correct height (3.16 and
3.17).
12. Remove cushion
I, II and III. (3:18).
4. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Installing the child seat forward facing can only be maid if the child
is more than 9 kg.
1. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (4.1).
2. Raise the backrest cover and insert the safety belt through red
waist belt guides B. Pass the waist belt through both red guides at
the base of the seat (4.2).
24 Child restraint system
1 and Group 0+ 2
Only suitable for Group 1, approx.
9 months to 4 years (9-18 Kg.)
base to use the seat with groups
SAVILE V8A