Settings For The Speakers; [Speaker Setup] - Sony DAV-IS10 Manual De Instrucciones

selects PCM, DTS, Dolby Digital sound, and MPEG
audio tracks in this order.
x [MULTI-DISC RESUME] (DVD VIDEO/
VIDEO CD only)
Switches the Multi-disc Resume setting on or
off.
[ON]
[OFF]
x [AUDIO DRC] (DVD VIDEO only)
Narrows the dynamic range of the sound track.
Useful for watching movies at low volume late
at night.
[OFF]
[STANDARD]
[MAX]
x [AUDIO (HDMI)]
Selects the audio output status from the HDMI
OUT jack.
[OFF]
[ON]
Note
• When you connect the control unit and TV with the
HDMI cable and [ON] is selected, AUDIO DRC, A/
V SYNC, TONE, MOVIE/MUSIC, and sound field
are not applied to the sound that is output from the
TV.
x [DivX]
Displays the registration code for this system.
For more information, go to
http://www.divx.com on the Internet.
92
GB
Stores the resume settings in
memory.
Does not store the resume settings
in memory. Playback restarts at
the resume point only for the
current disc in the system.
No compression of dynamic
range.
Reproduces the sound track with
the kind of dynamic range that the
recording engineer intended.
Compresses dynamic range fully.
The sound is not output from the
HDMI OUT jack.
Outputs audio signals by
converting Dolby Digital, DTS, or
96 kHz/24 bit PCM signals to 48
kHz/ 16 bit PCM.

Settings for the Speakers

[SPEAKER SETUP]

To obtain the best possible surround sound, set
connection of the speakers and their distance
from your listening position. Then use the test
tone to adjust the level and the balance of the
speakers to the same level.
Select [SPEAKER SETUP] in the Setup
Display. For details, see "Using the Setup
Display" (page 86).
The default settings are underlined.
SPEAKER SETUP
CONNECTION:
DISTANCE(FRONT):
DISTANCE(SURROUND):
LEVEL(FRONT):
LEVEL(SURROUND):
TEST TONE:
FRONT:
CENTER:
SURROUND:
SUBWOOFER:
To return to the default setting
when changing a setting
Select the item, then press CLEAR. Note that
only the [CONNECTION] setting does not
return to the default setting.
x[CONNECTION]
If you do not connect center or surround
speakers, set the parameters for [CENTER] and
[SURROUND]. Since the front speaker and
subwoofer setting is fixed, you cannot change
them.
[FRONT] [YES]
[CENTER] [YES]: Normally select this.
[NONE]: Select this if no center
speaker is used.
[SURROUND]
[YES]: Normally select this.
[NONE]: Select this if no
surround speaker is used.
[SUBWOOFER] [YES]
OFF
YES
YES
YES
YES