Working With The Electric Power Tool; Safe Working; Cross Cuts - Festool CSC SYS 50 EBI Manual De Instrucciones

English
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Saw blade change position
► Move the saw blade to the saw blade
change position with the control mod­
ule [14-9].
Removing the cover plate
► Move the sliding table [14-12] into the front
position. Use the locking lever [14-7] to
lock it in this position.
► Loosen the screw [14-11] on the cover plate
using the hex key [14-2] provided.
► Remove the cover plate [14-8].
Removing the saw blade
► Remove the spacer wedge [14-10] (see
Section 9.9)
► Push the spindle stop button [14-1] down­
wards and loosen the screw [14-3] using
the hex key (left-hand thread).
► Remove the screw and flange [14-4] and lift
the saw blade upwards to remove it.
Fitting the saw blade
► WARNING! Check the screws and flange for
contamination and only use clean and un­
damaged parts.
► Insert a new saw blade and outer flange.
WARNING! The direction of rotation of the
saw blade [14-5] and saw [14-6] must
match. Serious injuries may occur in the
event of non-compliance.
The labelling on the saw blade cannot be
seen while it is inserted.
► Tighten the screw (left-hand thread).
► Insert the cover plate [14-8] and screw it
into place.
► Insert the spacer wedge.
► Insert the hex key into the holder [1-10]
provided.
10 Working with the electric
power tool

10.1 Safe working

When working on the machine, observe
all of the safety warnings that are listed
at the start as well as the following rules:
36
Before starting
– Ensure that the saw blade protective cover
is undamaged and the saw blade is un­
touched at any cutting angles or cutting
heights. The flaps on the saw blade protec­
tive cover must be able to move freely.
– There must not be any damage to the plate,
cover plate and table insert (e.g. cuts in the
sawing gap). Replace any damaged parts
immediately.
– Never work without using a cover plate,
service flap or table insert.
– Check that the saw blade is securely in
place.
CAUTION! Risk of overheating. Before use,
–
make sure that the battery pack is securely
clicked into place.
– Position the workpiece so that it is stress-
free and level.
During work
– Risk of tilting. The power tool may tilt if at­
tempting to machine a workpiece that is too
large or too heavy.
– Do not wear protective gloves when sawing.
Protective gloves may become caught in
the saw blade and pull the hand into the
saw blade.
– Correct working position: On the side of the
sliding table next to the saw blade's line of
cut.
– Risk of injury from ejected parts. Any per­
sons standing in the vicinity of the saw may
be injured. Maintain distance from the saw.
– Adapt the infeed speed to prevent the cut­
ters on the saw blade from overheating and
prevent plastic materials from melting dur­
ing cutting. The harder the material to be
sawn, the lower the feed speed needs to be.
– Never change the position of the power tool
while the saw blade is running.
Store the push stick [1-12] in the push
–
stick holder (Fig. 1) when not in use.
10.2 Types of use
The saw can be used as
Sliding table saw
–
with sliding tables and cross stop.
Bench saw
–
with locked sliding table and stopper.

10.3 Cross cuts

Make cross cuts and angled cuts on the left
side of the power tool. Always use the preset
profile setting rail (see Section 9.14).