Foreword; Important Safety Information - Nederman FlexFilter EX Manual De Instrucciones

FlexFilter EX
EN

Foreword

This manual contains instructions and warnings and constitutes the documentation that must be supplied and
kept together with the product; otherwise the product would be lacking in one of its fundamental safety requisites.
The manual must be kept with care and made available to all persons involved in operating the equipment .
The warnings are intended to ensure the safety of persons exposed to the risks inherent in the operation and
handling of this equipment .
This product is designed to meet the requirements of the relevant EC directives . To maintain this status all instal-
lation, repair and maintenance work must be carried out by qualified personnel using only original spare parts.
Contact your nearest authorised dealer or AB Ph . Nederman & Co . for advice on technical service or if you require
spare parts .
IMPORTANT! SAFETY INFORMATION
FlexFilter EX is designed for collecting and filtering combustible and non-combustible dry dust. The filter
should not be used for filtering fumes from welding processes.
FlexFilter EX must be installed, used and maintained according to this Instruction Manual in such a way that safe-
ty not will be neglected . The manual contains important warning directions which have to be read and followed .
Any functional disorders, especially those affecting the safety of the machine, must be rectified immediately.
Standards relating to the connection and use of filters in hazardous areas must be taken into consideration, espe-
cially national standards for installation. Only trained personnel familiar with these standards should handle this
type of filters.
FlexFilter EX is specially designed to comply with official regulations concerning the risk of explosion. If improp-
erly used, badly connected, or altered, no matter how minor, the safety and reliability could be jeopardized.
Each FlexFilter EX system must be dimensioned individually. To ensure that the system will be safe, a risk analysis
must be performed for each installation and intended use .
Grinding, welding or other hot works on the filter exterior or duct system should not be done without first stopping
and cleaning the system .
Access to the FlexFilter EX shall be restricted to authorised personnel only .
Place fire alarms and appropriate extinguishing system in all locations where the collected dust is stored.
22