Astralpool PC95 Manual De Instrucciones página 48

7___ CONTRO PROCEDURES
7.1___ON / OFF
Enter the programming menu (See Page 16) and go to the PRG2 function.
VARIABLES
PH SETTINGS
SET
ALL
ALH
REL
PRS
DEL
SPM
BP
REG
OUT
HIS
MMA
RMA
PHS
PHE
CHLORINE SETTINGS
SET
ALL
ALH
REL
PRS
DEL
SPM
BP
REG
OUT
HIS
MMA
RMA
CLS
CLE
CTP
CPH
ENABLING
EN
ID
BR
By selecting the variables REG = ONOF and OUT = MIS in the menu, it will be possible to have
the variables indicated above.
If OUT = REG , the variables to be set for the pH and for the CHLORINE will only be those
variables that are underscored.
DEFAULT VALUES
7,20 pH
6,50 pH
7,90 pH
ACID
NO
0 Seconds
20 Seconds
0,50 pH
ONOF
MIS / REG
0,00 pH
0,1 mA
4-20 mA
0 pH
14,00 pH
0.60 ppm
0.30 ppm
1.50 ppm
LO
NO
0 Seconds
20 Seconds
0.50 pH
ONOF
MIS / REG
0.00 ppm
0.1 mA
4-20 mA
0 ppm
5.00 ppm
0 %/°C
OFF
SC
1
2400
COMMENTS
SET POINT pH
PH minimum alarm
PH maximum alarm
Type of control
Status of the pH relay
Delay time, pH metering
Strokes/minute, Output
Freq.
Proportional band
Control mode
Working mode Output mA
Hysteresis
OFFSET OUTPUT IN mA
MA output dynamics
Initial value for reg. mA
End value for per reg. mA
Chlorine SET POINT
Chlorine minimum alarm
Chlorine maximum alarm
Type of control
Status of chlorine relay
Chlorine-metering delay
time
Strokes/minute, Output
Freq.
Proportional band
Control mode
MA output working mode
Hysteresis
OFFSET OUTPUT IN mA
MA output dynamics
Initial value for mA control
End value for per mA
control
Coefficient for offsetting the the
measured value in relation to the
%/°C.
temperature expressed in
Enabling of correction of the
chlorine measurement in
relation to the pH.
Enables the Cal and Set
keys
Indicates the ID of the multi-
point .serial network
Baud rate of RS485 serial
link
19