Control Panel - Astralpool PC95 Manual De Instrucciones

3___CONTROL PANEL

GENERAL DESCRIPTION OF THE KEYPAD
This key displays the set points that have been set. If this
function is enabled, it can be used to change the value.
Pressed together with the MAN, it can be used to force the
status of the setting relays.
It this key is pressed, the indication PrOG will appear. If it
is kept pressed for 5 seconds, the programming mode will
be entered. If this key is inhibited by the protection
provided on the terminal strip, when it is pressed the
indication dIS will appear.
If the programming mode has been entered, programming
will move ahead by one step each time this key is
pressed.
This key takes programming back step by step. If it is kept
pressed for 5 seconds, the programming function is exited,
saving all the data in the permanent storage.
This switches off the alarm relay, however if the alarm
status persists, the appropriate LED will stop flashing and
remain steady on until the cause of the alarm is
eliminated. It resets an error message and reinstate the
incorrect datum by default.
This key increments the value being displayed during the
programming procedure. It increments the value displayed
by pressing the SET key.
It displays the reference temperature ( manual or
automatic). If the temperature is manual, it should be
pressed at the same time as the DOWN key.
This key can be used to change the temperature value. It
decrements the value that is displayed during the
programming mode. It decrements the value that is
displayed by pressing the SET key.
It enables the manual function, and if it is pressed together
with the SET key, it can be used to force the relays
controlling the pumps in the manual mode.
This key can be used to enter the Calibration Menu.
5