Mechanical Installation - WEG DBW03 Serie Manual Del Usuario

Installation and Connection

3.2 MECHANICAL INSTALLATION

Mount the module in the upright position on a flat surface.
Observe the clearances shown in figure 3.1 to allow the circulation of cooling air.
External dimensions and position of fixation points are presented in Section
7.3 - Mechanical Data.
First put the screws on the surface where the module will be installed, install the
module and then tighten the screws. Four M6 screws are used (recommended torque:
8.5 N.m) for fixing the module.
Do not install heat sensitive components just above the module.
100 mm (3.93 in)
  
130 mm (5.11 in)
Figure 3.1: Ventilation clearances
DBW03 | 17