Models And Description Of The Components; Models; Description Of The Components - Carel gaSteam 45 Manual Del Usuario

1. MODELS AND DESCRIPTION OF THE COMPONENTS

1.1 Models

The code that marks the model of humidifi er is made up of 10 characters (Fig. 1.a and Table 1.a).
Example: the code UG180HD001 identifi es a gas-fi red humidifi er (UG) with:
• rated steam production 180 kg/h (180);
• modulating control (H);
• 230 Vac single-phase power supply (D).
Important note: the humidifi er is factory-set for a maximum production equal to the 70% of the rated
value. To change the maximum production see the chapter "Humidifi er control", parameter P0.

1.2 Description of the components

gaSteam HARDWARE +030220538 - rel. 1.4 - 22.01.2008
Fig. 1.b
UG xxx x x 0 0 1
1 2 3 4
1 family prefi x
2 rated instant steam production in kg/h: 045; 090 and 180
3 type of control: H= modulating*
4 type: V
power supply voltage: D= 230 - 1~N
5 options: 0= basic version
6 not used
7 internal updating use
*= includes the following types of operation: ON-OFF, proportio-
nal, humidity and temperature.
1 water on-off tap
2 fi ll solenoid valve
3 foam detection electrode
4 steam outlets
5 boiler
6 fl ue gas
7 electrical panel
8 fl ue gas temperature sensor (2 ea. for UG180)
9 level sensor
10 preheating temperature sensor
11 heat exchanger (2 ea. for UG180)
12 air inlet
13 gas line
14 gas on-off tap
15 gas burner (2 ea. for UG180)
16 drain and pre-fi ll valve
17 fi lter
18 drain pump
19 drain network
20 conductivity meter
21 drain pipe
22 water line
23 safety thermostat
24 botton tank drain pipe
7
5 6 7
Fig. 1.a