Securing Fabric In The Embroidery Hoop; Attaching The Embroidery Hoop To The Machine; Removing The Hoop From The Machine - Singer EM200 Manual De Instrucciones

E
MBROIDERY
SECURING FABRIC IN EMBROIDERY
HOOP
For the best embroidery results, place a layer of stabilizer
beneath the fabric. When hooping stabilizer and fabric make
sure that they are smooth and securely hooped.
1. Open the quick release lever on the outer hoop and remove
the inner hoop.
2. Place the outer hoop on a fi rm fl at surface with the screw
on the lower right. There is a small arrow in the center of
the left edge of the outer hoop which will line up with a
small arrow on the inner hoop.
3. Place stabilizer and the fabric, with the right sides facing
up, on top of the outer hoop.
2
1
4. Place the inner hoop on top of the fabric with the small
arrow at the left edge and push fi rmly into the outer hoop.
5. Close the quick release lever. Don't force the quick release
lever. If it seems as though it doesn't want close, loosen the
retaining screw fi rst and then try closing the quick release
lever again.
6. Adjust the pressure of the outer hoop by turning the
retaining screw. The fabric should be taut in the hoop for
the best results.
4
NOTE:
When embroidering additional designs on the same fabric,
open the quick release lever, move the hoop to the new
position on the fabric and close the quick release lever. When
changing type of fabric, you might need to adjust the pressure
using the retaining screw. Do not force the quick release lever.
P
REPARATION
3
5
6
ATTACHING THE EMBROIDERY HOOP
TO THE MACHINE
1. Raise the presser foot. Raise the needle to its highest
position by turning the hand wheel toward you.
2. Slide the hoop onto the embroidery unit from front to back
until it clicks into place.
NOTE:
Presser foot lever can be raised and held in a higher position
to help passing the hoop under the foot.
a
R H
EMOVING THE OOP
Press and hold the release lever (a) on the hoop connection
assembly, then slide the hoop toward you.
19
F M
ROM THE ACHINE