Winding Bobbin Independently; Inserting The Bobbin - Singer EM200 Manual De Instrucciones

T
HREADING THE
W B I
INDING OBBIN NDEPENDENTLY
You can wind the bobbin independently while embroidery
stitching.
1. Insert the auxiliary spool pin into the hole at the left side on
the top of the machine.
2. Place the felt washer and spool of thread onto the auxiliary
spool pin.
3. Bring thread to the right and hook the thread to the thread
guide from rear opening.
4. Follow the normal winding procedure from Steps 2 to 9 (on
page 12).
M
ACHINE
13
I B
NSERTING THE OBBIN
1. Place bobbin into bobbin holder, making sure the bobbin
turns in a counter clockwise direction.
2. Draw thread into notch (a) while holding the bobbin.
3. Pull thread along the groove, up and around the top, to the
left, then down.
While lightly holding the bobbin in place with your fi nger,
pull the thread to the right to cut the thread.
4. Replace the bobbin cover. Set the left tabs into the holes in
needle plate and push the right side of bobbin cover down
until it clicks into place.
NOTE:
This machine can start to sew without manually drawing up the
bobbin thread.
If you want to draw up the bobbin thread manually, see page
15.
Be sure to use only SINGER® Class 15 transparent bobbins in
this machine.
a