Editing The Design; Embroidery Placement Screen; Embroidery Rotation And Mirroring Screen; Embroidery Scaling Screen - Singer EM200 Manual De Instrucciones

E
DITING THE
Before you begin embroidering, you can edit designs, as
shown below, using the Edit tabs.
NOTE:
The pop up message may appear if you did not attach the
correct hoop.
Press "✓" button and attach the hoop indicated in this message
or change hoop size setting at the Embroidery Option screen
(Next page).

EMBROIDERY PLACEMENT SCREEN

You can move the placement or position of the selected
embroidery design, as follows:
1. Press the Embroidery Placement tab.
(When you have selected the design, this screen will
appear fi rst.)
2. Press the four arrow buttons to move the position.
a: up, b: left, c: right, d: down
The hoop will move according to the direction selected.
Each time the button is touched, the hoop will move. If the
button is touched and held, the movement will occur in
larger increments.
The values (X:Y:) near the top of the screen indicate
distance from center position.
NOTE:
The left side of screen is indicating embroidery fi eld and
relative design position and size.
When you edit the design, this fi eld will redraw according to
your editing.
1
D
ESIGN
2
a
b
c
d
e
EMBROIDERY ROTATION AND
MIRRORING SCREEN
1. Press the Embroidery Rotate and Mirroring tab.
2. Press the Rotate button. By pressing this button, the design
will rotate 90 degrees clockwise. If the design is too wide or
too high to rotate 90 degrees, it will rotate 180 degrees.
The total rotation value will be indicated at the top right of
the LCD screen. Located to the left of the rotation value is
a 'machine icon', which will rotate as the rotation value is
changed.
3. Press the Mirror buttons.
a. Mirror from top to bottom
b. Mirror from side to side
The 'machine icon' (located near the top of the LCD screen)
will invert according to the selections made, indicating the
new orientation of the embroidery design.
1

EMBROIDERY SCALING SCREEN

1. Press the Embroidery Scaling tab.
2. To increase the scale, press the upper arrow button (a).
To decrease the scale, press the lower arrow button (b).
The design will be scaled 5 percent each pressing on a
button.
The maximum scaling is +/- 20 percent.
If scaling is over the hoop size, it cannot be selected.
To return to original size, press the button (c).
The value of scale is indicated between the buttons, and
size of scaled design is indicated on the top line of screen.
21
2
3
a
b
2
a
b
c
1