Important Safety Instructions - Singer EM200 Manual De Instrucciones

This household embroidery machine is designed to comply with IEC/EN 60335-2-28 and UL
1594.

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic safety precautions should always be followed,
including the following:
Read all instructions before using this household embroidery machine. Keep these instructions
conveniently near the machine. Make sure to hand them over if the machine is given to a third
party.
DANGER
To reduce the risk of electric shock:
An embroidery machine should never be left unattended when plugged in. Always unplug
this embroidery machine from the electric outlet immediately after using and before cleaning,
removing covers or when making any other user servicing adjustments mentioned in the
instruction manual.
WARNING
To reduce the risk of burns, fi re, electric shock, or injury to persons:
• Do not allow to be used as a toy. Close attention is necessary when this embroidery machine
is used by or near children.
• Use this embroidery machine only for its intended use as described in this manual. Use only
attachments recommended by the manufacturer as contained in this manual.
• Never operate this embroidery machine if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water. Return the embroidery
machine to the nearest authorized service center for examination, repair, electrical or
mechanical adjustment.
• Never operate the embroidery machine with any air openings blocked. Keep ventilation
openings of the embroidery machine free from the accumulation of lint, dust, and loose fabric.
• Keep fi ngers away from all moving parts. Special care is required around the embroidery
machine needle.
• Always use the proper needle plate. The wrong plate can cause the needle to break.
• Do not use bent needles.
• Do not pull or push fabric while stitching. It may defl ect the needle causing it to break.
• Wear safety glasses.
• Switch the embroidery machine off ("0") when making any adjustment in the needle area,
such as threading needle, changing needle, threading bobbin, changing presser foot, etc.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
• To disconnect, turn all controls to the off ("0") position, then remove plug from outlet.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Do not use the machine if it is wet.
• If the LED lamp is damaged or broken, it must be replaced by the manufacturer or its service
agent or a similarly qualifi ed person, in order to avoid a hazard.
I S
MPORTANT AFETY
2
I
NSTRUCTIONS