Pop-Up Messages; Upper Thread Breakage; Connect Usb; Thread Jam - Singer EM200 Manual De Instrucciones

U T B
PPER HREAD REAKAGE
When the upper thread breaks or
runs out, this pop-up will appear
and sewing will stop.
Re-thread the upper thread and
press "✓" button.
Go back 3-4 stitches backward
from broken point by pressing "-"
at sewing screen.
Press the Start/Stop button to
restart sewing.
C USB
ONNECT
This pop-up will appear if the USB
button is pressed without any
USB stick connected or if the USB
stick is removed during browsing
of the stick or removed when
embroidering.
Connect USB stick and press the
"✓" button.
T J
HREAD AM
If upper or bobbin thread is
jammed under the needle plate,
machine will stop and pop-up this
message.
Remove the hoop and needle
plate (see next page) Remove the
thread jam and reset needle plate.
Press the "✓" button.
W H T
RONG OOP YPE
This pop-up will appear when
the selected hoop in the hoop
selection list is not the same
as the hoop attached to the
embroidery unit. Attach the correct
hoop type and press the "✓"
button.
T D USB
HE ATA ON THE
S C R
TICK ANNOT BE EAD
This pop-up will appear when
your embroidery machine cannot
access the information on the
USB stick. This can be caused
by wrong fi le formats on the USB
stick, the USB stick could be
damaged or you might be using a
USB stick that is non-compatible
with this machine.
P - M
OP UP
R H
EMOVE THE OOP
This pop-up will appear when a
function has been chosen that the
forces the embroidery unit to move
outside the limits for the attached
hoop. In order for the carriage to
move freely, remove the hoop and
then press the "✓" button.
E T L
MBROIDERY OO
This pop-up will appear if a design
is too large for this machine to
read from USB stick.
S C
TOP OMMAND IN
This pop-up will appear when
there is a programmed stop in
the design. The machine will
stop. Press "✓" button to continue
embroidering.
M M O
AIN OTOR VERLOAD
If you are sewing on very heavy
fabric or if the machine is blocked
when sewing, the main motor can
get overloaded and the machine
will stop sewing. The pop-up
message will close when the
main motor and power supply are
secure.
C D
ORRUPTED ATA
This pop-up will appear when
the content of the USB memory
is corrupted and cannot be read
correctly.
26
ESSAGES
ARGE
D
ESIGN