Helpful Hints - Singer EM200 Manual De Instrucciones

PROBLEM CAUSE
Machine not properly threaded.
Upper thread Thread entwined around bobbin.
breaks Needle inserted incorrectly.
Thread tension too tight.
Thread of incorrect size or poor quality.
Lower thread Bobbin threaded incorrectly.
breaks Bobbin wound unevenly or too full.
Dirt or lint in the bobbin holder.
Machine skips Needle inserted incorrectly.
stitches Bent or blunt needle.
Incorrect size of needle.
Machine not properly threaded.
Fabric puckers Bobbin threaded incorrectly.
Blunt needle.
Thread tension too tight.
Design too dense for fabric being
embroidered.
Insuffi cient stabilizer.
Machine makes Bobbin threaded incorrectly.
loose stitches or Machine not properly threaded.
loops Tension not adjusted properly.
Stitch pattern is Hoop or carriage is interferred.
distorted Thread tension is not balanced.
Insuffi cient stabilizer.
Threader does not Needle is not raised to highest position.
thread to needle Needle inserted incorrectly.
eye Bent needle.
Needle breaks Needle inserted incorrectly.
Incorrect size needle or thread for fabric.
Machine runs with Dirt or lint accumulated in the hook race.
diffi culty
Machine will not Cord not plugged into electrical outlet.
run Power switch is not turned on.
Presser foot is not lowered.
H H
ELPFUL
CORRECTION
Re-thread machine.
Remove entwined thread.
Re-insert needle.
Readjust thread tension.
Choose correct thread.
Re-thread the bobbin.
Rewind the bobbin.
Clean the holder.
Re-insert needle.
Insert new needle.
Choose correct size needle for fabric.
Re-thread machine.
Re-thread the bobbin.
Insert new needle.
Readjust thread tension.
Select less dense design for fabric, or change
fabric type.
Use proper stabilizer for fabric being
embroidered.
Re-thread the bobbin.
Re-thread machine.
Readjust thread tension.
Remove obstruction.
Adjust the thread tension.
Use proper stabilizer for fabric being
embroidered.
Raise the needle.
Re-insert needle.
Insert new needle.
Re-insert needle.
Choose correct size needle and thread.
Remove the needle plate and bobbin holder
and clean the hook race.
Insert plug fully into outlet.
Turn on the switch.
Lower the foot.
28
INTS
Page
14
13
7
16
7
13
12
27
7
7
7
14
13
7
16
20
18
13
14
16
24
16
18
15
7
7
7
7
27
8
8
10