Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
T
C
B
HREAD
UTTER
UTTON
By pressing this button, machine will cut both threads
automatically.
NOTE:
The machine will cut threads automatically between color
changes and when an embroidery design has been completed.
CAUTION:
1. Do not press this button when there is no fabric under the
presser foot or no need to cut the threads. The thread may
tangle, resulting in damage.
2. Do not use this button when cutting thread thicker than
#30, nylon thread or other speciality threads.
In this case, use the thread cutter (G).
T
C
(D)
OP
OVER
To open the top cover, lift up the front right side of the cover.
H
W
(E)
AND
HEEL
By turning the hand wheel, the needle will raise or lower. You
should always turn hand wheel toward you.
(C)
C
D
E
S
U
ETTING
P
F
L
RESSER
OOT
IFTER
The presser foot is raised or lowered by this lever.
You can raise and hold the presser foot lifter to an extra-high
position, which can help make it easier to install the embroidery
hoop.
NOTE:
Machine will not start when the presser foot is raised (except
for bobbin winding).
T
C
(G)
HREAD
UTTER
Use this cutter if the Thread Cutter button is not used.
1. Raise the presser foot and bring threads toward the back.
2. Hook the threads to the thread cutter from back to front.
3. Pull threads to cut them.
G
M
M
OUNTING
ACHINE IN
There are two holes on the underside of the machine designed
for mounting the machine into a sewing cabinet. Align the
holes (indicated in the picture) with the corresponding holes in
the cabinet base. Attach the machine with screws. (Screws not
included)
10
M
P THE
ACHINE
(F)
F
S
C
(H)
EWING
ABINET
H
Publicidad
Capítulos
Tabla de contenido
