Metabo HPT C 3607DRA Manual De Instrucciones página 24

English
7. Adjusting the guard (Fig. 21)
(1) Right angle cutting
Loosen the 6 mm knob bolt and contact the tip of the
guard with the workpiece.
Guard
Fence surface
CAUTION
In some arrangements when the turntable is rotated,
the guard projects from the fence surface. Loosen the
6 mm knob bolt and push the guard to the retracted
position. Never lift the lower guard while the saw
blade is rotating. When cutting at an angle of 45° to
the right or more, please slide the guard to the rear.
(Fig. 21)
The guard and sub-fence (A) and sub-fence (B) will
not only make contact and adversely aff ect cutting
accuracy, this could also result in damage to the guard.
8. Securing the workpiece
WARNING
Always clamp or vise to secure the workpiece
to the fence; otherwise the workpiece might be
thrust from the table and cause bodily harm.
9. Position adjustment of laser line
WARNING
○ Exercise utmost caution in handling a switch trigger
for the position adjustment of the laser line, as the
battery is installed during operation.
If the switch trigger is pulled inadvertently, the saw
blade can rotate and result in unexpected accidents.
○ Do not remove the laser marker to be used for other
purposes.
24
6 mm
knob bolt
Turntable
Fig. 21
CAUTION (Fig. 22)
○ Laser radiation - Do not stare into beam.
○ Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can
be hurt.
○ Do not dismantle it.
○ Do not give strong impact to the laser marker (main
body of tool); otherwise, the position of a laser line can
go out of order, resulting in the damage of the laser
marker as well as a shortened service life.
○ Keep the laser marker lit only during a cutting
operation. Prolonged lighting of the laser marker can
result in a shortened service life.
○ Use of controls or adjustments or performance of
procedures other than those specifi ed herein may
result in hazardous radiation exposure.
NOTE
○ Perform cutting by overlapping the ink line with the
laser line.
○ When the ink line and the laser line are overlapped,
the strength and weakness of light will change,
resulting in a stable cutting operation because you
can easily discern the conformity of lines. This
ensures the minimum cutting errors.
○ In outdoor or near-the-window operations, it may
become diffi cult to observe the laser line due to the
sunlight. Under such circumstances, move to a place
that is not directly under the sunlight and engage in
the operation.
Ink lining can be easily made on this tool to the laser
marker. A switch lights up the laser marker (Fig. 2, 3).
Depending upon your cutting choice, the laser line
can be aligned with the left side of the cutting width
(saw blade) or the ink line on the right side.
Fig. 22