Saw Blade Mounting And Dismounting - Metabo HPT C 3607DRA Manual De Instrucciones

SAW BLADE MOUNTING AND
DISMOUNTING
WARNING
To prevent an accident or personal injury, always
turn off the trigger switch and disconnect the
battery from the power tool before removing or
installing a saw blade.
1. Mounting the saw blade (Fig. 56-a, 56-b)
Gear Case
5 mm hex. bar wrench
Fig. 56-a
Spindle Lock
Washer (B)
Lower guard
Left hex. 7 mm
socket bolt
Washer (B)
Left hex. 7 mm
socket bolt
Fig. 56-b
(1) Press in spindle lock and loosen left hex. 7 mm socket
bolt with 5 mm hex. bar wrench (standard accessory).
Since the left hex. 7 mm socket bolt is left-hand
threaded, loosen by turning it to the right.
NOTE
If the spindle lock cannot be easily pressed in to lock
the spindle, turn the left hex. 7 mm socket bolt with
5 mm hex. bar wrench (standard accessory) while
applying pressure on the spindle lock.
The saw blade spindle is locked when the spindle lock
is pressed inward.
(2) Remove the bolt and washer (B)
(3) Lift the lower guard and mount the saw blade.
WARNING
When mounting the saw blade, confi rm that the
rotation indicator mark on the saw blade and the
rotation direction of the gear case are properly
matched.
(4) Thoroughly clean washer (A) and the left hex. 7 mm
socket bolt, and install them onto the saw blade
spindle.
(5) Press in the spindle lock and tighten the left hex.
7 mm socket bolt by turning it to the left by standard
accessories (5 mm hex. bar wrench).
CAUTION
○ A dust guide is installed inside behind the hinge.
When removing or installing the saw blade, do not
make contact with the dust guide. Contact may break
or chip saw blade tips.
English
Saw blade
Washer (A)
37