Metabo HPT C 3607DRA Manual De Instrucciones página 29

Stopper (B)
1
Fig. 32-a
(2) Lower the motor head, and turn the 8 mm depth
adjustment bolt and make adjustments so that there
can be a clearance of 2 mm to 3 mm between the
lower limit position of the motor head and the top of
the workpiece at the saw blade's lower limit position
where the head of the 8 mm depth adjustment bolt
contacts the hinge.
6 mm depth
adjustment bolt
Lower the motor head
2 - 3 mm
5
Workpiece
Fig. 32-b
Stopper holder
2
3
4
Hinge
6. Cutting wide workpieces (Slide cutting)
(1) Workpieces up to 58 mm high and 310 mm wide:
Loosen the slide securing wing bolt (Fig. 33), grip the
handle and slide the saw blade forward.
Then press down on the handle and slide the saw
blade back to cut the workpiece. This facilitates
cutting of workpieces of up to 58 mm in height and
310 mm in width.
Handle
Lower the
motor head
Push backward
3
to cut
(2) Workpieces up to 67 mm high and 263 mm wide:
Workpieces of up to 67 mm in height and up to
263 mm in width can be cut in the same manner as
described in paragraph 4 above.
(3) Spacers (D) can be used to minimize burrs on the
surface of materials when making slide cuts.
English
Loosen
Slide securing wing bolt
Pull forward
1
Press
2
down
Work piece
Fig. 33
29