Metabo HPT C 3607DRA Manual De Instrucciones página 35

WARNING
Always fi rmly clamp or vise to secure the crown
molding to the fence; otherwise the crown
molding might be thrust from the table and cause
bodily harm.
13. Groove cutting procedures
Cut grooves with saw blade
Stopper (B)
6 mm depth
adjustment bolt
Hinge
Saw blade
Workpiece
ⓐ
ⓑ
Fig. 49
Stopper holder
ⓐ
ⓑ
Fig. 50
Grooves in the workpiece can be cut by adjusting the
6 mm depth adjustment bolt (Fig. 50).
(1) Turn the stopper holder on the direction shown in
Fig. 50.
Lower the motor head, and turn the 6 mm depth
adjustment bolt by hand. (Where the head of the 6 mm
depth adjustment bolt contacts the hinge.)
(2) Adjust to the desired cutting depth by setting the
distance between the saw blade and the surface of
the base (Fig. 50).
NOTE
When cutting a single groove at either end of the
workpiece, remove the unneeded portion with a
chisel.
(3) If the height of ⓑ exceeds 20 mm, tip stopper
(B) forward and press the tip of the 6 mm depth
adjustment bolt against stopper (B).
NOTE
When using stopper (B), make sure to tip stopper (B)
forward before placing the stopper holder to the rear.
14. Using the dust bag (Standard accessory) (Fig. 51)
(1) Connect the dust bag with the duct of power tool.
(2) When the dust bag has become full of sawdust, dust
will be blown out of the dust bag when the saw blade
rotates.
Check the dust bag periodically and empty it before it
becomes full.
(3) During bevel and compound cutting, attach the dust
bag at the right angle to the base surface.
Dust bag
Duct
English
Gear Case
Fig. 51
35