Metabo HPT C 3607DRA Manual De Instrucciones página 27

2. Using the Vise Assembly (Standard accessory)
6 mm wing bolt Screw holder
Vise shaft
V-groove
Top of the fence
Fence
(A), (B)
6 mm knob bolt Groove
The vice assembly can be attached on the right or left
of the fence.
When attaching the vice assembly to the fence,
matching the groove or the v-groove of the vice shaft
to the upper surface of the fence will match the tip
of the 6 mm knob bolt at the rear of the fence to the
groove of the vice shaft.
This will allow 3 levels of height adjustment for the
vice shaft.
(1) Adjust so that the tip of the 6 mm knob bolt matches
the groove of the vice shaft, and tighten the 6 mm
knob bolt to secure the vice shaft.
(2) Adjust the position of the screw holder, and tighten
the 6 mm wing bolt on the rear of the screw holder to
secure the screw holder.
(3) Make sure to press the material against the surface
of the fence and secure the material by tightening the
knob.
WARNING
Always fi rmly clamp or vise to secure the
workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily
harm.
CAUTION
Always confi rm that the motor head does not contact
the vise assembly when it is lowered for cutting. If
there is any danger that it may do so, move the vise
assembly to a position where it will not contact the
saw blade.
Knob
Vise plate
Workpiece
Fence surface
Fig. 28
3. Cutting Operation
ⓐ
ⓐ
Marking
(pre-marked)
ⓐ
(1) As shown in Fig. 29 the width of the saw blade is the
width of the cut. Therefore, slide the workpiece to
the right (viewed from the operator's position) when
length ⓑ is desired, or to the left when length ⓐ is
desired.
If a laser marker is used, align the laser line with the
left side of the saw blade, and then align the ink line
with the laser line.
(2) Once the saw blade reaches maximum speed,
push the handle down carefully until the saw blade
approaches the workpiece.
(3) Once the saw blade contacts the workpiece, push the
handle down gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth,
turn the power tool OFF and let the saw blade stop
completely before raising the handle from the
workpiece to return it to the full retract position.
CAUTION
● For maximum dimensions for cutting, refer to
"SPECIFICATIONS" table on page 14.
● Increased pressure on the handle will not
increase the cutting speed.
On the contrary, too much pressure may result in
overload of the motor and/or decreased cutting
effi ciency.
WARNING
● Confi rm that the trigger switch is turned OFF and
the battery has been removed whenever the tool
is not in use.
English
ⓑ
Saw blade
ⓑ
Marking
(pre-marked)
ⓑ
Fig. 29
27