Metabo HPT C 3607DRA Manual De Instrucciones página 26

English
1. Switch operation
(1) Turning the saw on (Fig. 26)
For safe operation of the machine, a "switch lock" is
provided on the side of a handle.
If the "trigger switch" is pulled in a state where "switch
lock" is pressed in the direction of the arrow mark, the
main switch can be turned ON.
After the switch is on, the saw blade will continue to
operate as long as you pull on the trigger switch, even
if you release the switch lock.
Switch lock
Lighting Mode
LED Light (Right)
LED Light (Left)
CAUTION
When the LED light has been lit or after immediately
turning it off , the light lens becomes extremely hot and
should never be touched.
26
Trigger switch
Fig. 26
Both Sides Lit
Light ON
Light ON
(2) Turning the laser guide / LED light on (Fig. 27)
Switch
(For LED light)
LED light (left)
Laser marker
The laser line will light when the laser marker switch
is pressed on the switch panel. Press the switch once
more to turn it off .
You can switch the lighting mode of the LED light by
pressing the LED light switch. Turn the light off as
much as possible to minimize battery consumption.
Right Side Lit Left Side Lit
Light ON
Light OFF
NOTE
To minimize battery consumption when the LED
lights and/or laser marker are left on, the unit will
automatically switch them off if there is no operation
for approximately one hour.
Switch
(For laser marker)
Laser line
Fig. 27
Light OFF Light OFF
Light ON Light OFF
LED light
(right)
OFF