Metabo HPT C 3607DRA Manual De Instrucciones página 30

English
(a) Move the spacer (D) forward and place the
stopper holder to the rear. (Fig. 34-a)
Stopper (B)
Spacer (D)
Fig. 34-a
(b) Lower the head and with the cutting edge of the
sawblade in a position that lightly comes into
contact with the workpiece, turn the 6 mm depth
adjustment bolt so that the tip of the 6 mm bolt
bumps against the spacer (D). (Fig. 34-b)
6 mm depth
adjustment bolt
Fig. 34-b
(c) When you slide cut after returning spacer (D) to
the rear, there will be a groove of about 2 mm.
This will reduce scuffi ng of the workpiece's upper
surface. (Fig. 34-c)
Spacer (D)
Fig. 34-c
30
Stopper holder
2
1
3
4
5
(d) By moving the stopper holder forward and slide
cutting once again, you can cut the workpiece.
CAUTION
● When cutting a workpiece of 67 mm height,
adjust the lower limit position of the motor head
so that the gap between the lower edge of the
motor head and the workpiece will be 2 to 3 mm
at the lower limit position. Refer to "5. Cutting
large workpieces" on page 28.
● If the handle is pressed down with excessive or
lateral force, the saw blade may vibrate during
the cutting operation and cause unwanted
cutting marks on the workpiece, thus reducing
the quality of the cut.
Accordingly, press the handle down gently and
carefully.
● In slide cutting, gently push the handle back
(rearwards) in a single, smooth operation.
Stopping the handle movement during the cut will
cause unwanted cutting marks on the workpiece.
WARNING
● For slide cutting, follow the procedures.
Forward slide cutting (toward the operator) is
very dangerous because the saw blade could
kick upward from the workpiece. Therefore,
always slide the handle away from the operator.
● Always return the carriage to the full rear position
after each crosscut operation in order to reduce
the risk of injury.
● Never put your hand on the side handle during
the cutting operation because the saw blade
comes close to the miter lock handle when the
motor head is lowered.
7. Miter cutting procedures
Miter scale indicator
(For degrees scale)
Miter scale
(Gradient scale)
Miter scale indicator
(For gradient scale)
Miter scale
(Degrees scale)
Turntable
Side handle
Lever
Fig. 35