Metabo HPT C 3607DRA Manual De Instrucciones página 33

For miter cut setting
If the turntable has been set to either of the angles
described, move the turntable adjusting side handle a
little to the right and left to stabilize the position and to
properly align the miter angle scale and the tip of the
indicator before the operation starts.
For bevel cut setting
Turn the clamp lever on bevel section to the left and
check that the position is stable and that the bevel
angle scale and the tip of the indicator are properly
aligned. Then tighten the clamp lever.
Type of Crown Molding
To process crown molding at
positions 1 and 4 in Fig. 40.
Miter Angle Setting
Bevel Angle Setting
To process crown molding at
positions 2 and 3 in Fig. 40.
Miter Angle Setting
Bevel Angle Setting
(1) Setting to cut crown moldings at positions 1 and 4
in Fig. 40 (see Fig. 41; tilt the motor head to the left):
1 Turn the turntable to the right and set the Miter Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the upper surface
(Ⓐ in Fig. 39) contacts the fence as indicated in Fig. 43.
45° Type 38° Type
right right
35.3° 31.6°
( mark) ( mark)
left left
(2) Setting to cut crown moldings at positions 2 and 3
30° 33.9°
( mark) ( mark)
1 Turn the turntable to the left and set the Miter Angle as
left left
35.3° 31.6°
( mark) ( mark)
2 Tilt the head to the left and set the Bevel Angle as
left left
30° 33.9°
( mark) ( mark)
3 Position the crown molding so that the lower surface
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Indicator
(For left bevel scale)
Fence (A)
Fence (B)
Inside corner
Turntable
Fig. 41
in Fig. 40 (see Fig. 42; tilt the head to the left):
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
(Ⓑ in Fig. 39) contacts the fence as in Fig. 44.
Inside corner
Fig. 42
English
Base
Upper surface of
crown molding
Outside corner
Miter scale indicator
(For degrees scale)
Miter scale
(Degrees scale)
35.3°
31.6°
30°
33.9°
Indicator
(For left bevel scale)
Base
Lower surface of
crown molding
Outside corner
33