Switching Weight Unit; Check Weighing - Mettler Toledo IND221 Instrucciones De Manejo

4.2 Switching weight unit

For this purpose, F2.1=Unit must be set in the operator menu.
➜ Press
.
F
The weight value is displayed in the second weight unit.
Note
The displayed weight unit remains until it is switched again.

4.3 Check weighing

For this purpose, F2.1=OVEr and F2.2.1=CHECh (factory setting) must be set in the op-
erator menu. In the factory setting, the check weighing function is working with upper and low-
er tolerances of 10 d. With parameters F2.2.3 and F2.2.4, these tolerances can be custom-
ized.
Setting target weight
1. Press to activate the check weighing function.
F
2. Press and hold
If F2.2.2=WEIGHt (factory setting) is set in the operator menu, the weight display appears.
3. Put the target weight on the weighing platform and save with
The OK indicator lights.
If F2.2.2=MAnUAL is set in the operator menu, the weight display with blinking last digit
appears.
3. Enter target weight using the
page 19).
4. Save entered weight value as target weight using the
F
until tArGEt and the 3 indicators Under, OK and Over appear.
F
T
, and
F
14
.
F
keys and confirm with
key.
F
(see