Aros 10000P Manual De Instrucciones página 76

5. After the above verifications have been accomplished, please use the
following instructions to physically connect the inverter to the AC grid.
Connect your PV-Inverter to the AC-connection unit via the AC-output cable and
ground cable as shown in the following steps:
Use a cable size between "Suggested min. wire area [mm
allowed wire area [mm
Open the AC-output cover with a screwdriver and unscrew the AC and ground
cable glands.
Remove the rubber bushing from cable gland 2, cut the bushing according to the
AC cable size and pass the cable through cable gland 2.
If grounding is available locally (for example on a tracker), remove the plug from
cable gland 3 and pass the ground cable through it.
Connect the AC and ground cables to the terminal block, screw back the cover
and tighten cable glands 2 and 3.
Page 76
- ENGLISH -
2
]" in Table 1 in the Appendix.
1
3
2
2
1) Communication slot
2) AC-cable gland
3) Ground cable gland
]" and "Maximum