Troubleshooting; Troubleshooting Table - Medela Freestyle Flex Instrucciones De Uso

Ocultar thumbs Ver también para Freestyle Flex:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13. Troubleshooting

In case of an unexpected behaviour of your breast pump check with the troubleshooting table
if you find the issue in the column "Problem" and follow the instructions in the column "Solu-
tion".

Troubleshooting table

Problem
The breast pump does not
enter the standby mode
after you pressed the On/
Off button
The display does not light
up after you pressed the
On/Off button
The timer does not count up
after you pressed the Start/
Pause button
The breast pump generates
no vacuum (motor not
working) after you pressed
the Start/Pause button
The breast pump generates
only constant vacuum
instead of sucking cycles
The breast pump stops
operation or cannot be
turned on (emits an audio
signal and all elements of
the battery display are
flashing)
Solution
• You pressed the On/Off button for too short or too long
a time.
• Press the On/Off button until you hear an audio signal,
then release it. If the pump is in storage mode, it will take
somewhat longer (approx. one second) until the audio
signal is emitted.
• To reset your breast pump, press and hold the On/Off
button (on the side) for seven to ten seconds.
• If there is no change, make sure that the breast pump is
connected to a properly working power supply.
• If there is still no change, contact the Medela Customer
Service.
• Contact the Medela Customer Service.
• Make sure that the breast pump is switched on.
• Contact the Medela Customer Service.
• Contact the Medela Customer Service.
• The breast pump refuses operation due to battery
over-temperature. Allow the motor unit to cool down,
then restart the breast pump.
41

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido