Troubleshooting; Troubleshooting Table - Medela Freestyle Hands-free Instrucciones De Uso

12. Troubleshooting

In case of an unexpected behavior of your breast pump, check with the troubleshooting table
if you find the issue in the column "Problem" and follow the instructions in the column "Solution".

Troubleshooting table

28
Problem
The breast pump does
not enter the standby
mode after you pressed
the On/Off button
The display does not light
up after you pressed the
On/Off button
The timer does not count
up after you pressed the
Start/Pause button
The breast pump
generates no vacuum
(motor not working)
after you pressed the
Start/Pause button
The breast pump
generates only constant
vacuum instead of
sucking cycles
The breast pump stops
operation or cannot be
turned on (emits an audio
signal and all elements
of the battery display
are flashing)
Solution
• You pressed the On/Off button for too short or too long
a time.
• Press the On/Off button until you hear an audio signal,
then release it. If the pump is in storage mode, it will take
somewhat longer (approx. one second) until the audio
signal is emitted.
• To reset your breast pump, press and hold the On/Off
button (on the side) for seven to ten seconds.
• If there is no change, make sure that the breast pump
is connected to a properly working power supply.
• If there is still no change, contact the Medela Customer
Service.
• Contact the Medela Customer Service.
• Make sure that the breast pump is switched on.
• Contact the Medela Customer Service.
• Contact the Medela Customer Service.
• The breast pump refuses operation due to battery
over-heating. Allow the motor unit to cool down,
then restart the breast pump.