Determination Of The Row Distance (Magica 7) - GASPARDO MAGICA Empleo Y Mantenimiento

ENGLISH
5.3 DETERMINATION OF THE ROW DISTANCE
MAGICA 7 rows
The Magica 7 row planting unit was designed along the lines of
the 6 row version, adding a seventh seeding element, fastened
at the centre of the machine. The interrows, 45 - 50 - 60 cm (Fig.
24/a), are obtained by moving the 6 side elements.
It is of vital importance that all maintenance, adjustments and pre-
paratory operations be carried out with the tractor's power take-off
disconnected, the planting unit resting on the ground on its support
feet, the tractor engine off, the vehicle completely motionless and the
ignition key removed. All of the above described operations must
be performed by skilled personnel wearing protective gloves in
a clean, dust-free environment. Before putting the equipment
into operation, check the area around the machine to ensure
that there are no people, especially children or small domestic
animals, nearby and to ensure that visibility is perfect.
DETERMINATION OF THE INTERROW SPACING (45-50-60)
The following operations must be carried out with the machine off.
To set the planting interrow spacing, proceed as follows:
1) Activate the tractor's hydraulic system to reclose the seeding
elements, then open the side frames.
2) Move the lower knuckle pins in the guide holes corresponding
to the interrow to be set (Example Fig. 20).
3) Position the upper pins in the holes corresponding to the
interrow to be set (Fig. 24/b).
4) Start up the hydraulic system in order to open the elements
until they strike home, once the position of the knuckle pins
and pins has been determined.
fi g. 24/b
60 50 45
50 cm 50 cm
70 75
80
70 cm 70 cm
60 - EN
MAGICA 7 rows
WARNING
MAGICA 7 rows 45-50-60 cm
45 50 60
45
50
60
50 cm
MAGICA 6 rows 70-75-80 cm
80
70 75
75
USE AND MAINTENANCE
fi g. 24/a
50 cm
70
70 75
70 cm
-
60 50 45
45
50
60
50 cm
75 70
80
70 cm
45 50 60
50 cm
75 70
80
70 cm
cod. G19503321