GASPARDO MAGICA Empleo Y Mantenimiento página 61

5.3.1 TRANSFORMATION from 7 to 6 rows (70-75-80 cm)
Operations to be performed with the machine on the ground.
In order to sow at 70, 75 or 80 cm (Fig. 25), the planting unit
must be modifi ed from 7 to 6 planting rows. Remove the central
seeding element, taking care to follow the instructions provided
below (Fig. 27):
(1) Fit the parallelogram stop block in the central element;
(2) With the element in the operating position, completely lower
the equipment to ground level and block the front clod breaker;
(3) Slide out the suction tube;
(4) Disengage the cardan drive shaft of the seeding element;
(5) Remove the screws of the parallelogram and slide out the
seeding element;
(6) Fit the cardan shaft in the support provided and fasten it to the
parallelogram stop block. Place the suction tube in the ring.
If the planting unit is equipped with a microgranulator, proceed
as follows:
- close all the MINIMAX distributors of the central microgranulator
box (Fig. 26);
- Insert the retainer (7) to lock the rack (8), as indicated in fi gure
26, and loosen the screw (9) to disable the gear.
- remove the left seed drop tube (distribution on central seeding
element);
- move the central tube onto the left distributor;
- open the right and left MINIMAX distributor.
To set interrow spacing at 70, 75 or 80, refer to the diagram
in Figure 24/b. It is important to remember that to change the
interrow spacing, the upper and lower knuckle pins must be
moved.
1
4
2
cod. G19503321
3
-
USE AND MAINTENANCE
fi g. 25
6 F 7 5
6 F 8 0
8 0 0
6
8 0 0 8 0 0
4 0 0 0
fi g. 26
7
9
5
ENGLISH
8 0 0 8 0 0
8
CLOSED
fi g. 27
EN - 61