Set Button; Res Button - Waeco MagicSpeed MS-BE4 Instrucciones De Montaje

MS-be4 24/06/03
SET button (see
After switching on the cruise control using the ON/OFF button (status LED on the
ON/OFF switch turns green), the current speed can be taken over by pressing the SET
button (status LED turns orange).
Accelerating. When the system is activated (status LED orange), the vehicle's speed can
be increased by keeping the SET button pressed down. The speed increases by approx.
2.5 km/h every second. After releasing the SET-button the attained speed is maintained.
Acceleration by tapping. Briefly tapping the SET button increases the speed by approx. 1
km/h for each keystroke.
RES button (see
After switching on the cruise control using the ON/OFF button (status LED in the ON/OFF
switch turns green) the speed at which the vehicle was last driven can be set. The speed
is stored, the current speed is maintained.
Decelerating. When the system is activated (status LED orange), the vehicle's speed can
be increased by keeping the RES button pressed down. The speed reduces by approx.
2.5 km/h every second. After releasing the RES button the achieved speed is maintained.
Deceleration by tapping. Briefly tapping the RES button reduces the speed by approx.
1 km/h for each keystroke.
15:24 Page 14

SET button

E).

RES button

F).
14 14