Introduction; Safety Instructions; Product Description - Mettler Toledo InPro3200 Manual De Instrucciones

InPro 3200 (SG) pH electrode
1

Introduction

METTLER TOLEDO pH sensors type InPro
maintenance electrodes with pressurized gel-electrolyte,
silver-ion trap and built-in temperature sensor.
The InPro 3200 sensors are suitable for the same
applications as the corresponding DPA(S) sensors
without RTD, and provide an additional temperature
signal for automatic temperature compensation of the
pH signal during calibration and operation.
InPro 3200 sensors are autoclavable and in-situ
sterilizable.
2

Safety instructions

The sensor consists partly of glass and should be handled
carefully. If the sensor is to be cleaned or calibrated using
acid or alkaline solutions, safety goggles and gloves
should be worn. Local safety regulations are applicable
to the handling of the sensor. Please follow the guidelines
enclosed for an installation in the Ex zone. Please take
extra care during installation / fitting of the sensor to
ensure that neither the polymer body/shaft of the sensor
nor the thread (Pg 13.5) suffer any injury or damage.
We recommend that you only operate the electrode
in combination with original parts from METTLER
TOLEDO. Operation and maintenance should be carried
out only by trained personnel and staff who have read
and understood the operating instructions.
3

Product description

The inscription on each electrode contains the following
information:
METTLER TOLEDO
InPro
®
combination pH
pH 0...14
0 ... 100 °C (140 °C)
Order No. 52 00X XXX
II 1/2G Ex ia IIC T6/T5/T4 E x classification
SNCH 00 ATEX 3130 X
See instruction manual
In addition, each electrode is allocated a serial
number on the red part of the plug-in head to enable
identification.
© 03 / 16 Mettler-Toledo GmbH
Printed in Switzerland
3200 / SG / xxx / yyy
Manufacturer of the electrode
T ype designation / SG = ancillary
electrode / xxx = rod length in
mm / yyy = temperature sensor
Type of electrode
pH measurement range
Temperature range for operation
(sterilization)
Order number
I dentification and number
of certificate
I nstruction (Observe the operating
instructions)
InPro 3200 (SG) pH electrode
en
15
3200 are low-
®
52 001 518