Camera Installation; Mounting The Camera - Panasonic WV-CW970 Instrucciones De Operación

Camera installation

Mounting the Camera

Wall mount
The figure shows an example of the camera mounted
on a wall with the optional WV-Q122 Wall Mount
Bracket. See instructions included with the optional
bracket.
Ceiling mount
The figure shows an example of the camera mounted
on a ceiling with a locally procured bracket.
Refer to the instructions included with the bracket for
filling gaps and holes with waterproof material.
Construction
40 1-1/2B deep 30 MAX
PT11 crest (taper pipe thread)
40 1-1/2A deep 30 MAX
PT11 crest (parallel pipe thread)
Assemble procedure
1. Preparations
(1) Procure a ceiling mount bracket.
(2) To prevent the camera from falling, use a
mounting a bracket to which a safety wire can
be attached.
(60) 25
85
(3) Installation Surface
Caution: Consult an expert on the load bearing
capacity of the installation surface and
structure. If the surface is not strong enough,
the camera may fall down. Refer to the
product specifications for weights.
Prepare appropriate hardware (e.g. wall nuts,
anchor bolts, etc.) for fixing on the installation
surface.
2. Disassembling the Camera
(1) Remove the upper base from the camera by
loosening 3 screws. The screws that are
removed need to be used during reassembly.
Be careful to not lose them. Turn the upper base
and separate it.
* Special screw (mounting screw): Use a
hexagon wrench for the hexagon screw (M6).
(2) Remove the attachment pipe from the upper
base by loosening 4 screws.
* Special screw (mounting screw): Use a
hexagon wrench for the hexagon screw (M6).
-15-
x3
x4