Moving And Storage; Troubleshooting - Tunturi platinum 8610 Manual Del Usario

no one on it. After a few minutes of use, the running belt
should have a tendency to center itself. If, during use, the
belt continues to move toward one side, adjustments are
necessary.
Exception: During rehabilitation where the user is using
one leg much stronger than the other, it might happen that
the running belt drifts to one side. In these cases you should
not adjust unless the running belt does not centre itself
during normal condition usage.
To set running belt tracking:
A 10 mm Allen wrench is provided to adjust the rear roller.
Make tracking adjustments from the left side only. Set belt
speed at approximately 3 to 5 kph.
Remember, a small adjustment can make a dramatic
difference!
Turn the bolt clockwise to move the belt to the right.
Counterclockwise to move to the left.Turn the bolt only a
1/4 turn and wait a few minutes for the belt to adjust itself.
Continue to make 1/4 rotation turns until the belt stabilizes
in the center of the running deck.
The belt may require periodic tracking adjustment
depending on use and walking/running characteristics.
Some users will affect tracking differently. Expect to make
adjustments as required to center the tread-belt. Adjustments
will become less of a maintenance concern as the belt
is used. Proper belt tracking is an owner responsibility
common with all treadmills.
Damage to the running belt resulting from improper
tracking /tension adjustments is not covered under the
warranty.

Troubleshooting

Despite continuous quality control, defects and malfunctions
caused by individual components may occur in the
equipment. In most cases it's unnecessary to take the whole
device in for repair, as it's usually suffi cient to replace the
defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer immediately. Always give the
model and serial number of your equipment. Please state
also the nature of the problem, conditions of use and
purchase date.
English
12
If you require spare parts, always give the model, serial
number of your equipment and the spare part number for
the part you need. The spare part list is at the back of this
manual. Use only spare parts mentioned in the spare part
list.

Moving and storage

Move the Platinum Treadmill treadmill according to the
following instructions: turn off the power switch and
unplug the power cord from the wall and the treadmill.
Stand behind the treadmill and take hold of the aluminium
profi le at the rear end of the treadmill. Tilt the rear end of
the equipment so that it rests on the transportation wheels,
and move the equipment by wheeling. Lower the treadmill
carefully onto the fl oor.
Transport the treadmill with extreme caution over uneven
surfaces, for example over a step. The treadmill should
never be transported upstairs using the wheels over
the steps, instead it must be carried. We recommend
that you use a protective base when transporting the
equipment. The running belt needs to be realigned and
centered after moving.
To prevent malfunctioning of the treadmill, store it in a
dry place with as little temperature variation as possible,
protected against dust. Always unplug the treadmill from
the electrical outlet when not in use.