Waeco MagicSpeed MS700 Instrucciones De Montaje Y De Uso página 66

MS-700.qxd 24/06/03 15:19 Page 66
Accessories
Vehicles equipped with front wheel drive (see I 1)
Prevent the rear wheel from moving away, apply the hand brake and move the gearshift
to neutral. Lift the front of the vehicle high enough that there is sufficient working space
available. Support the front of the vehicle using support brackets. Never work under a
vehicle that is not adequately secured. Fasten the sensor to the mounting and determine
the installation position. This position should be as close as possible to the gear. The
suitable assembly location for the magnets is the inner joint of the drive shaft. Fix 2
magnets to the joint with double-sided adhesive tape and secure the fixed magnets with
the cable clips after distributing these uniformly on the joint.
Position the sensor so that there is a distance of approx. 3-5 mm arises between the
magnets and the cruise sensor. Ensure that the distance between sensor and the
magnets does not decrease or become larger than 5 mm as a result of the vertical
movement of the drive shaft.
Vehicles with rear-wheel drive (see I 2)
Prevent the front wheels from moving away and move the gearshift to neutral. Lift the rear
of the vehicle high enough that there is sufficient workingspace available. Support the
front of the vehicle using support brackets. Never work under a vehicle that is not
adequately secured. Fasten the sensor to the mounting and determine the installation
position. This position should be as close as possible to the gear. The suitable assembly
location for the magnets is directly in the gearbox. Fix 1 or 2 magnets on the cardan shaft
with double-sided adhesive tape and fasten the fixed magnets with the cable clips after
you have distributed these evenly on the joint. Position the sensor sothat there is a
distance of approx. 3-5 mm between the magnets and the cruise sensor. Ensure that the
distance between sensor and magnets does not decrease orbecomes larger than 5 mm
as a result of the vertical movement of the drive shaft.
Speedometer shaft generator MS-AA-144 (see I 3)
The speedometer shaft generator is used to generate a cruise signal in vehicles with a
screwed speedometer shaft. When using the speedometer shaft generator in vehicles
with manual transmission, it is absolutely imperative to install engine overspeed
protection.
66