CAMPAGNOLO BORA WTO 2-WAY FIT Manual Del Usuario página 21

2 - TIRES
2-Way Fit rims are designed for both tubeless / tubeless ready and
standard clinchers.
2.1 - INSTALLING CLINCHER TIRES
• Before fitting the tyres check that the diameter indicated on the tyre is
622 mm and that the width of the tyre is compatible with the width of the
rim as indicated in the rim/tyre compatibility table on page 3.
WARNING!
RIM-TIRE COMPATIBILITY
• All Campagnolo rims are made with very precise dimensionally.
If a tire is too easy to install on a Campagnolo rim, that tire is
most likely too big and will not seat properly on the rim. If a tire
is too difficult to install, that tire is most likely too small. Use only
high quality tires that require the use of tire levers and a reasona-
ble installation effort. Using talcum powder on the tire will make
installation easier. Using a tire that does not fit properly on the
rim can cause sudden and unexpected tire failure, resulting in an
accident, personal injury or death.
• Incorrect rim / clincher tyre coupling may cause it to deflate, burst
or detach suddenly and cause accidents, serious injuries or even
death.
• Failure to properly install the tire can cause sudden and unex-
pected loss of tire pressure, resulting in an accident, personal injury
or death.
4
TYRE
BEAD
RIM
1
Be sure that you do not damage or otherwise bend any portion of the rim when installing
the tire. Be careful not to damage or bend any part of the rim when mounting the tyre.
Damaging the edge of the rim can compromise its operation, especially when using
tubeless tyres. Check that the inside of the tyre and rim are perfectly clean; clean them
with a cloth if necessary.
WARNING: If you are unable to fit and remove the tyres by hand use plastic tyre
levers (never use metallic levers because you could damage the rim and the tyre).
• Fit the first bead of the tyre into the rim groove (Fig. 1) starting from the point opposite
the valve.
• Introduce a partially inflated presta inner tube into the tyre (Fig. 2).
2