Q.anti-Tip Swing Away; Gt W/Xtr Suspension Anti-Tip Tubes; Rear Axle Plate Suspension - Quickie GT Manual De Instrucciones

E N G L I S H
Q. ANTI-TIP SWING AWAY
1. Swing-Away Anti-Tip
The anti-tip wheel may have to be raised or lowered to achieve proper clearance of 1 1/2" to
2".
To adjust, using an Allen key and wrench, remove bolt (A) from current position. Adjust to
proper height, reinsert bolt, and tighten back into place.
2. Positioning Swing-Away Anti-Tip
The Swing-Away Anti-Tip can be positioned in the forward position when the wheelchair is
being pushed by the attendant, overcoming obstacles or climbing curbs. Press release tab (B)
in a downward motion and swing the anti-tip to either the forward or rearward position. The
anti-tip will lock back into place by moving upward. Remember to return the anti-tip to the
rearward position after completing the maneuver.
R. GT W/XTR SUSPENSION ANTI-TIP TUBES
Sunrise Medical recommends anti-tip tubes for all wheelchairs.
NOTE– Use torque setting of 100 in./lbs. when setting-up anti-tip tubes.
1. Inserting Anti-tip Tubes Into Receiver
a. Press the rear anti-tip release lever on the anti-tip tube so that both release pins are
drawn inside.
b. Insert the tube into the anti-tip receiver.
c. Turn the anti-tip tube down until release pin is through the receiver mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-tip Receiver
a. Remove anti-tip tubes from anti-tip receivers.
b. Remove button head bolt from anti-tip tube receiver.
c. Reposition bracket to desired height.
d. Reinsert button-head bolt and tighten.
e. Repeat with second anti-tip tube receiver. Both brackets should be at exactly the same
height.
3. Adjusting Anti-Tip Tube Wheel
The anti-tip wheels may have to be raised or lowered to achieve proper clearance of
1 1/2" to 2".
Press the anti-tip wheel release button so that both release pins are drawn inside. Raise or
lower to one of the three predrilled holes. Release button. Adjust the second anti-tip tube
wheel the same way. Both wheels should be exactly the same height.
4. Turning Anti-Tip Tubes Up
Turn anti-tip tubes when being pushed by attendant, overcoming obstacles or climbing curbs.
Press the rear anti-tip tube release lever. Hold lever in and turn anti-tip tube up. Release the
lever and repeat with second anti-tip tube. Remember to return anti-tip tubes to down posi-
tion after completing maneuver.
S. REAR AXLE PLATE SUSPENSION
The performance of your suspension system is determined by the compression elastomers
(C). There are several different elastomers available from Quickie which are selected based
on the user's weight.
To change out elastomers, remove the 2 screws (D) (1 per side). Rotate swingarms (E)
downward and the compression elastomer (C) can be freely removed from its top and bot-
tom engagement sockets.
Reverse the order to install new bushings, making sure the compression elastomers are
securely engaged into the top and bottom sockets.
109880 Rev. B
37
(Optional)
40
20
38 39
IX.
37
A
B
38
39
40
C
E
D