Install Rastofix; Control Box; Wiring - Invacare Medley Ergo Manual Del Usuario

3.4 Install Rastofix

(optional)
1. Press bottom of Rastofix at the foot end of the bed.
2. Squeeze upper end of Rastofix together.
3. Rotate Rastofix between tabs and release.

3.5 Control Box

The control box is latched to the backrest motor.
The control box A is provided with a locking cam B and a
label with symbols showing where to connect the motor
plugs:
• Backrest motor C
• Thigh section's motor D
• Bed end motor, foot end E
• Bed end motor, head end F
• Hand control G

3.6 Wiring

IMPORTANT!
– The cables must be mounted in such a way
that they are kept clear off the floor and do
not block the castors. Mount the mains cable
on the hook for this purpose, see image.
1556305-H
In order to prevent the cables from being damaged when
activating the motors, follow the instructions below.
1.
Connect both plugs from the hi/lo motors (head end
and foot end) to the control box placed underneath the
backrest.
2.
Guide the hi/lo motor cable from the bed foot end and
the cable from the thigh/leg section motor through the
thigh/leg section motor pipe pin. Make sure the pipe
pin is properly locked.
3. Connect the control box to the mains.
4. Run the thigh/leg section to its highest positions .
5.
Place the cable hi/lo motor in the foot end on the hook
at the bed end.
6. Run the backrest to its highest position
7.
Place the cable from the hi/lo motor in the head end,
on the two hooks at the bed end and attach the cable
in the backrest motor pipe pin.
Setup
11