Mounting The Cutting Attachment - Stihl FSB-KM Manual De Instrucciones

5
b
4
6
Slide the deflector (3) onto the drive
N
tube (4) so that the bead (a) on the
drive tube engages the guide (b) in
the deflector.
Push the deflector (3) into position
N
until the set screw (5) engages.
Tighten down the clamp screw (6)
N
firmly.
FSB-KM
Mounting the Cutting
Attachment
Placing power tool on the ground
3
Switch off the engine.
N
Lay your trimmer on its back with
N
the loop handle and shroud pointing
down and the output shaft facing up.
Thrust Plate
1
3
2
4
The thrust plate is supplied with the
DuroCut 5-2 and is only required for this
mowing head.
Mowing head STIHL AutoCut 5-2,
mowing head STIHL AutoCut C 6-2.
STIHL PolyCut 7-3 mowing head
Remove thrust plate (1), if present,
N
from shaft (2)
STIHL DuroCut 5-2 mowing head
Push the thrust plate (1) onto the
N
shaft (2) by inserting the internal
hexagon (3) onto the hexagon (4)
English
13