Mounting The Cutting Attachment - Stihl FS 300 Manual De Instrucciones

English
Fitting the Skirt
When using mowing heads
3
1
2
1
The deflector for metal mowing
attachments (1) must be equipped with
the skirt (2) when you use mowing
heads.
Slide the lower guide slot (3) of the
N
skirt (2) onto the deflector (1) – it
must snap into position.
62
Mounting the Blade
When using nylon line mowing heads
4
2
1
4
2
1
The deflector for metal mowing
attachments (1) must be equipped with
the line limiter blade (4) when you use
nylon line mowing heads.
Push the blade (4) into the upper
N
guide slot (5) on the skirt (2) and
line it up with the first hole.
Insert the screw and tighten it down
N
firmly.
Mounting the Cutting
Attachment
Placing power tool on the ground
5
N
N
Mounting hardware
Dependent on the cutting attachment
supplied as original equipment with a
new machine, the mounting hardware
supplied can also vary.
The mounting hardware is attached to
the gearbox for transport and has to be
removed before fitting a cutting
attachment.
Shut off the engine.
Lay your power tool on its back so
that the cutting attachment
mounting face is pointing up.
FS 300, FS 350, FS 380