salmson IXENS Serie Instalacion Y Puesta En Servicio página 110

English
No. Designation
1.0.0.0 Setpoint
2.0.0.0 Control mode
2.3.2.0 Δp-v gradient
3.0.0.0 Pump on/off
4.0.0.0 Information
4.1.0.0 Actual values
4.1.1.0 Actual values sen-
sor (IN1)
4.1.3.0 Power
4.2.0.0 Operating data
4.2.1.0 Operating hours
4.2.2.0 Consumption
4.2.3.0 Countdown, pump
cycling
102
NOTE:
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment under menu number
<5.4.1.0> is set to "OFF", the number <5.4.2.0> will be hidden. Menu
number <5.4.2.0> will only be visible if menu number <5.4.1.0> has
been set to "ON".
Type Symbol Values/explanations
±
Setting/display of the setpoint
(for further information, see
chapter 8.6.1 "Adjusting the
setpoint" on page 98)
±
Setting/display of the control
mode
(for further information, see
chapters 6.2 "Control modes" on
page 78 and 9.4 "Setting the
control mode" on page 110)
Constant speed control
Constant control Δp-c
Variable Δp-v control
PID control
Setting the gradient of Δp-v
(value in %)
±
ON
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode
Δp-c, Δp-v: Value H in m
PID control: Value in %
Current power input P
Display of operating data
The pump's total active operat-
ing hours (counter can be reset
via the infrared interface)
Energy consumption in
kWh/MWh
Time to pump cycling in h (at a
resolution of 0.1 h)
Display conditions
Not displayed for all pump
types.
Not displayed for manual
control mode
in W
1
The operating data refer to
the electronic module cur-
rently being operated
Shown only for double pump
master and internal pump
cycling Can be set in the ser-
vice menu <5.1.3.0>
Salmson 05/2015