salmson IXENS Serie Instalacion Y Puesta En Servicio página 107

8.6.2 Changing to menu mode
2 s
ON
1
12.3
Fig. 38: Standard menu mode
2 s
ON
1
12.3
Fig. 39: Service menu mode
E000
Fig. 40: Error case menu mode
8.6.3 Navigation
±
1.0.0.0
±
2.0.0.0
4.0.0.0 4.1.0.0
5.0.0.0 4.2.0.0
4.4.0.0
Fig. 41: Navigation example
Installation and operating instructions Ixens, Ixens Bloc
2 s
• While the display is showing the status page, press the white button
±
2.0.0.0
±
5.0.0.0
±
6.0.0.0
2 s
• Change to menu mode (see chapter 8.6.2 "Changing to menu mode"
• To select the menu element, turn the white button.
• If the downward pointing arrow for "One level down" is shown, press
4.4.1.0
4.4.3.0
• To return to the next higher menu level, select the "One level up"
To change to menu mode, proceed as follows:
for two seconds (except in case of an error).
Standard behaviour:
The display changes to menu mode. Menu number <2.0.0.0> is dis-
played (Fig. 38).
Service mode:
If service mode is activated via DIP switch 1 menu number <5.0.0.0>
is displayed first (Fig. 39).
Error case:
In case of error, menu number <6.0.0.0> is displayed (Fig. 40).
on page 99).
Carry out general menu navigation as follows (for an example, see
Fig. 41):
During navigation, the menu number flashes.
The menu number is incremented up or down. The symbol associated
with the menu element and the setpoint or actual value are shown, if
applicable.
the white button to change to the next level down. The new menu
level is labelled on the display by the menu number, e.g., when chang-
ing from <4.4.0.0> to <4.4.1.0>.
The symbol for the menu element and/or the current value (setpoint,
actual value or selection) is shown.
menu element and press the white button.
The new menu level is labelled on the display by the menu number,
e.g., when changing from <4.4.1.0> to <4.4.0.0>.
NOTE:
If the white button is pressed for two seconds while a "One level up"
menu element is selected, the display jumps back to the status page.
English
99