Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Interim Storage; Shipping - salmson IXENS Serie Instalacion Y Puesta En Servicio

2.7 Unauthorised modification and
manufacture of spare parts
2.8

Improper use

3

Transport and interim storage

3.1

Shipping

Transport inspection
Storage
3.2 Transport for installation/
dismantling purposes
Fig. 8: Transporting the pump
Installation and operating instructions Ixens, Ixens Bloc
Unauthorised modification and manufacture of spare parts will impair
the safety of the product/personnel and will make void the manufac-
turer's declarations regarding safety.
Modifications to the product are only permissible after consultation
with the manufacturer. Original spare parts and accessories author-
ised by the manufacturer ensure safety. The use of other parts will
absolve us of liability for consequential events.
The operating safety of the supplied product is only guaranteed for
conventional use in accordance with chapter 4 of the operating
instructions. The limit values must on no account fall under or exceed
those specified in the catalogue/data sheet.
The pump is delivered from the factory packaged in a cardboard box
or secured to a pallet and protected against dust and moisture.
On arrival, inspect the pump immediately for any transport damage.
If damage is detected, the necessary steps involving the forwarding
agent must be taken within the specified period.
Before installation, the pump must be kept dry, frost-free and pro-
tected from mechanical damage.
CAUTION! Risk of damage due to incorrect packaging!
If the pump is transported again at a later time, it must be packaged
so that it cannot be damaged during transport.
• Use the original packaging for this, or choose equivalent packag-
ing.
• Check the transport eyes before use for damage and secure fixa-
tion.
WARNING! Risk of injury!
Improper transport can lead to personal injury.
• The pump must be transported using approved lifting gear
(e.g. block and tackle, crane, etc.). These are to be attached to the
transport eyes at the motor flange (Fig. 8, shown here: lifting
direction with vertical motor shaft).
• If necessary, e.g. in case of repairs, the transport eyes can be
moved from the motor flange to the motor housing (see e.g. Fig. 9).
Before installing the transport eyes at the motor housing, unscrew
the spacers from the openings for the transport eyes (Fig. 7,
Item 20b) (see chapter 10.2.1 "Replacing the mechanical seal" on
page 113).
• Before using the transport eyes, check the eyes for damage and
ensure that the fastening screws are completely screwed in and
tightened.
English
71