Amann Girrbach ceramill zolid Instrucciones De Uso página 30

A P P L I C A T I O N
▷ Clean the frames from residual zirconia dust using a brush or com-
pressed air.
E N ▷ Depending on requirement, the frames or the fully anatomical den-
ture can be partially or completely colored with Ceramill Liquid dye
solutions (see processing instructions for Ceramill Liquid dye solu-
tions).
Final sintering
For sintering, a separate sintering bowl (178370) and sintering pearls
(178311) are used.
Loss of translucence!
▷ The sintering bowl with the pearls are to be used only for Ceramill
Zolid and not for Ceramill ZI applications!
▷ Do not sinter Ceramill Zolid and Ceramill ZI frames together in one
sintering bowl!
30
The Ceramill Therm high-temperature furnace (178300/
178350) or another high-quality and suitable furnace is rec-
ommended for the sintering (please also refer to the operat-
ing instructions of the respective sintering furnace).
NOTE:
Ceramill Zolid frames and ZI frames may be sintered together
in one sintering process in separate, stacked sintering bowls.
Sintering bowls can only be stacked in the Ceramill Therm II
(178350).