Ki Mobility Little Wave FLIP XP Manual De Instrucciones Y Garantía página 35

V. SET UP & USE OF YOUR WHEELCHAIR
P. Reclining Backrest
Instructions for Use:
Recline / Incline:
1. Unlock the system prior to recline or incline adjustment by removing the locking pin from the the
locking hole on each recline trigger (Fig. 35).
2. Ensure wheel locks are engaged and wheelchair is on a level surface.
3. Grip the handles securely and slowly depress both reclining triggers (Fig. 36) at the same time
to release the gas cylinders. This will allow you to adjust the backrest position as follows:
a. Reclining - to open the angle of the backrest relative to the seat frame, or recline, by apply-
ing downward force on gas springs.
b. Inclining - return to upright position by applying force upward and pushing the backrest
towards the front of the wheelchair.
4. Once desired backrest recline angle has been achieved, slowly release both reclining triggers.
5. To lock the system, insert the locking pin into the locking pin hole (Fig. 35). It is recommended
that you always lock both reclining backrest triggers when you are done positioning the patient.
Fig. 35
Locking Pin
(Same on
opposite
side)
Fig. 36
Recline Trigger
(Same on
opposite side)
33